Operation

The standard front and available rear heating-A/C systems used in this vehicle are blend-air type systems. In a blend-air system, a blend-air door controls the amount of conditioned air that is a ...

A/C Performance

The A/C system is designed to provide the passenger compartment with low temperature and low humidity air. The A/C evaporator, located in the HVAC housing is cooled to temperatures near the fre ...

See also:

REPLACEMENT BULBS
All the inside bulbs are brass or glass wedge base. Aluminum base bulbs are not approved and should not be used for replacement. LIGHT BULBS – Interior Bulb Number Courtesy/Reading Lamps (Incand ...

With intermediate shaft
NOTE: Never grasp the halfshaft assembly by the inner or outer boots. This can cause damage to the boot, which will allow contaminants to enter the C/V joint. NOTE: The inner tripod joints ...

Hydraulic pressure tests
Fig. 4: Identifying Transmission Electrical Connectors NOTE: Before preforming the hydraulic pressure tests be certain to disconnect the Variable Line Pressure (VLP) electrical connector (2 ...