Installation

NOTE: Perform 1 through 6 on each side of vehicle to complete pad set installation, then proceed to 7. CAUTION: Anytime the brake rotor or brake pads are being replaced, the rear cal ...

Removal

LEFT-HAND-DRIVE 1. Disconnect and isolate the battery negative cable from its post on the battery. 2. If equipped, remove the silencer pad below the steering column opening cover. Fig. 132: S ...

See also:

Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...

Removal, Installation
REMOVAL WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negat ...

Fluid
STANDARD PROCEDURE FLUID LEVEL AND CONDITION CHECK FLUID LEVEL CHECK Fig. 351: Identifying Fluid Level Indicator - FLUID LEVEL INDICATOR NOTE: Only transmission fluid of the type labele ...