Installation

NOTE: Perform 1 through 5 on each side of the vehicle to complete pad set installation, then proceed to 6. NOTE: Make sure that the audible wear indicator (if equipped) is placed toward ...

Removal

1. Raise and support vehicle. NOTE: Perform 2 through 5 on each side of vehicle to complete pad set removal. Fig. 124: TIRE AND WHEEL MOUNTING 2. Remove wheel mounting nuts (3), then tire ...

See also:

Installation
2.4L Fig. 7: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m (88.5 ft. lbs.). 2. Connect electrical connect ...

TIRE CHAINS
Due to limited clearance, tire chains are not recommended. CAUTION: Damage to the vehicle may result if tire chains are used. ...

Description, standard procedure
DESCRIPTION Fig. 163: Engine Block & Crankshaft - MAIN CAP BOLT-VERTICAL - MAIN CAP - MAIN BEARING-LOWER - MAIN BEARING-UPPER - MAIN CAP BOLT - HORIZONTAL - CYLINDER BLOCK - CRA ...