Installation

NOTE: Before stabilizer bar installation, inspect the cushions and links for excessive wear, cracks, damage and distortion. Replace any pieces failing inspection. NOTE: Before installing the ...

Description, Operation

DESCRIPTION A Macpherson type design strut assembly is used in place of the traditional front suspension upper control arm and upper ball joint. The bottom of the strut mounts directly to the stee ...

See also:

Removal
NOTE: Before proceeding, review all Warnings and Cautions. 1. Raise and support the vehicle. Fig. 39: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts (3), then the tire and wheel a ...

Switch, oil pressure
Description The engine oil pressure switch is located on the right side of the engine block. The switch screws into the engine main oil gallery. The normally closed switch provides an input throug ...

Actuator, blend door, rear
DESCRIPTION Fig. 47: Rear Actuator Description The blend door actuator (1) for the rear heating-A/C system is a reversible, 12 volt direct current (DC), servo motor. The rear blend door actuato ...