Valves, intake and exhaust

Description The valves are made of heat resistant steel, and have chrome plated stems to prevent scuffing. The four valves per cylinder (two intake and two exhaust) are actuated by roller rocker a ...

Description, standard procedure

DESCRIPTION Fig. 163: Engine Block & Crankshaft - MAIN CAP BOLT-VERTICAL - MAIN CAP - MAIN BEARING-LOWER - MAIN BEARING-UPPER - MAIN CAP BOLT - HORIZONTAL - CYLINDER BLOCK - CRA ...

See also:

Removal
2.0L TURBO DIESEL Fig. 2: Generator Cables 1. Remove engine cover. 2. Disconnect and isolate the negative battery cable. 3. Remove accessory drive belt. 4. Disconnect battery cable fro ...

Hub and bearing
DESCRIPTION Fig. 31: Front Hub And Bearing Mounting The front wheel bearing and wheel hub of this vehicle are a one piece sealed unit or hub and bearing unit type assembly. The hub and beari ...

Removal
LEFT-HAND-DRIVE 1. Disconnect and isolate the battery negative cable from its post on the battery. 2. If equipped, remove the silencer pad below the steering column opening cover. Fig. 132: S ...