Pipe, exhaust

REMOVAL 2.7L/3.5L Fig. 20: Exhaust Pipe - 2.7L/3.5L - EXHAUST PIPE - NUTS - CROSS UNDER PIPE - GASKET WARNING: The normal operating temperature of the exhaust system is ver ...

Removal

2.7L ENGINE Fig. 22: Belly Pan - BELLY PAN - EXHAUST EXTENSION PIPE 1. Remove the belly pan (2). Fig. 23: 2.7L Extension Pipe 2. Remove the fasteners (1), and remove the exhaust extens ...

See also:

Removal
Fig. 93: Accessory Drive Belt System - 2.7L - GENERATOR - IDLER/TENSIONER 1. Perform fuel pressure release procedure before attempting any repairs. 2. Disconnect negative cable from rem ...

Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...

Installation
Fig. 25: Ball Joint Installation 1. Install Installer (2), Special Tool 9964-1, and Installer (4), Special Tool 9964-2 on Remover/Installer (5), Special Tool 8441-1. Place a new ball joint (stem ...