Electrical

...

Description, Operation

DESCRIPTION Fig. 1: Battery Components This vehicle is equipped with a single 12-volt battery. All of the components of the battery system are located in the front of the vehicle, just ahead of ...

See also:

Removal
1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

Standard Procedure
MASTER CYLINDER BLEEDING 1. Clamp the master cylinder in a vise with soft-jaw caps. Fig. 88: BLEEDING MASTER CYLINDER WITH ABS 2. Thread a Bleeder Tube (2), Special Tool 8358-1, into the primary ...

Module, satellite video
REMOVAL 1. Disconnect and isolate the negative battery cable. 2. Move the front passenger seat to the most forward position. Fig. 8: Antenna & Electrical Connectors 3. Disconnect the three ...