Dodge Journey: HAZARD WARNING FLASHER

switch is located in theThe Hazard Warning flasher
switch is located in the instrument panel switch bank, above the climate controls.

Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flasher.

This is an emergency warning system and it should not be used when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.

When you must leave the vehicle to seek assistance, the Hazard Warning flasher will continue to operate even though the ignition switch is in the LOCK position.

NOTE: With extended use, the Hazard Warning flasher may wear down your battery.

    IF YOUR ENGINE OVERHEATS
    In any of the following situations, you can reduce the potential for overheating by taking the appropriate action. • On the highways — Slow down. • In city traffic — While stopped, put the ...

    See also:

    REMOTE STARTING SYSTEM — IF EQUIPPED
    This system uses the Remote Keyless Entry (RKE) transmitter to start the engine conveniently from outside the vehicle while still maintaining security. The system has a range of approximately 300 f ...

    Assembly
    Fig. 257: Installing Input Shaft - INPUT SHAFT - ARBOR PRESS - INPUT SHAFT HUB ASSEMBLY Use petrolatum on all seals to ease assembly of components. 1. Using an arbor press (2), install ...

    Engine diagnosis
    ENGINE DIAGNOSIS - INTRODUCTION Engine diagnosis is helpful in determining the causes of malfunctions not detected and remedied by routine maintenance. These malfunctions may be classified as e ...

    0.3197