With intermediate shaft

NOTE: Never grasp the halfshaft assembly by the inner or outer boots. This can cause damage to the boot, which will allow contaminants to enter the C/V joint. NOTE: The inner tripod joints ...

Without intermediate shaft

NOTE: The inner tripod joints are designed with a retention feature that prevents the tripod rollers from coming out of the inner joint housing up to a specific load. If this feature is o ...

See also:

Relay, heater unit
DESCRIPTION Fig. 320: Standard ISO-Type Relay Three relays (1) are used for the electric positive temperature coefficient (PTC) heater system when equipped with the 2.0L diesel engine. The rela ...

Engine diagnosis
ENGINE DIAGNOSIS - INTRODUCTION Engine diagnosis is helpful in determining the causes of malfunctions not detected and remedied by routine maintenance. These malfunctions may be classified as e ...

Reinforcement, bumper, rear
REMOVAL Fig. 25: Rear Bumper Reinforcement 1. Remove rear fascia. See Removal . 2. Support bumper reinforcement (1) on a suitable lifting device. 3. Mark position of bolts (2) on frame rail ...