Installation

1. Guide the trailing end of the parking brake cable along the inboard side of the axle trailing arm up to the rear brake caliper. Make sure the cable is routed between the brake line and the tra ...

Removal

FOOT OPERATED PARKING BRAKE LEVER 1. Release the parking brake. 2. Raise and support the vehicle. 3. Manually release the parking brake cable tension. 4. Push the front cable strand into ...

See also:

Removal, Installation
REMOVAL Fig. 54: Removing /Installing Propeller Shaft CAUTION: Propeller shaft removal is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while o ...

Removal
2.4L Fig. 3: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Disconnect and isolate negative battery cable at battery. 2. Remove engine cover. 3. Remove electrical connector (3). ...

Installation
NOTE: Before stabilizer bar installation, inspect the cushions and links for excessive wear, cracks, damage and distortion. Replace any pieces failing inspection. NOTE: Before installing the ...