Dodge Journey: CD/DVD DISC MAINTENANCE

To keep a CD/DVD in good condition, take the following precautions:
1. Handle the disc by its edge; avoid touching the surface.

2. If the disc is stained, clean the surface with a soft cloth, wiping from center to edge.

3. Do not apply paper or tape to the disc; avoid scratching the disc.

4. Do not use solvents such as benzene, thinner, cleaners, or anti-static sprays.

5. Store the disc in its case after playing.

6. Do not expose the disc to direct sunlight.

7. Do not store the disc where temperatures may become too high.

NOTE: If you experience difficulty in playing a particular disc, it may be damaged (i.e., scratched, reflective coating removed, a hair, moisture or dew on the disc) oversized, or have protection encoding. Try a known good disc before considering disc player service.

    REMOTE SOUND SYSTEM CONTROLS — IF EQUIPPED
    The remote sound system controls are located on the rear surface of the steering wheel. The left and right-hand controls are rocker-type switches with a pushbutton in the center of each switch. Rea ...

    RADIO OPERATION AND CELLULAR PHONES
    Under certain conditions, the cellular phone being on in your vehicle can cause erratic or noisy performance from your radio. This condition may be lessened or eliminated by relocating the cellular ...

    See also:

    Description, Operation, Diagnosis and Testing
    DESCRIPTION The lubrication system is a full-flow filtration, pressure feed type. The oil pump body is mounted to the engine block. The pump inner rotor is driven by the crankshaft. A structural w ...

    Removal, Installation
    REMOVAL 1. Remove transmission and torque converter from vehicle. 2. Place a suitable drain pan under the converter housing end of the transmission. CAUTION: Verify that transmission is ...

    Description, Operation
    DESCRIPTION Fig. 29: Removing/Installing ECM - 2.0L Diesel The ECM (3) is located in the left side of engine compartment attached to the left inner fender below the air filter housing. OPERAT ...

    0.0147