Assembly

Fig. 257: Installing Input Shaft - INPUT SHAFT - ARBOR PRESS - INPUT SHAFT HUB ASSEMBLY Use petrolatum on all seals to ease assembly of components. 1. Using an arbor press (2), install ...

Description, Operation

DESCRIPTION Fig. 297: Identifying Solenoid/Pressure Switch Assembly - SOLENOID AND PRESSURE SWITCH ASSEMBLY The Solenoid/Pressure Switch Assembly (1) is external to the transaxle and mount ...

See also:

Insulator, engine mount, right
Removal Fig. 243: Belly Pan 1. Remove the belly pan (2). Fig. 244: Right Engine Mount 2. Lower vehicle. Remove the load on the engine motor mounts by carefully supporting the engine assembly ...

Standard Procedure
MASTER CYLINDER BLEEDING 1. Clamp the master cylinder in a vise with soft-jaw caps. Fig. 88: BLEEDING MASTER CYLINDER WITH ABS 2. Thread a Bleeder Tube (2), Special Tool 8358-1, into the primary ...

Description, Operation
DESCRIPTION Fig. 139: Blower Motor-PM The blower motor (1) is used to control the velocity of air moving through the HVAC housing by spinning the blower wheel (2) within the HVAC air inlet hous ...