Installation

CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant oil level will prevent the A/C system fro ...

Description

Fig. 297: Underbody Lines Models equipped with the rear heating-A/C system use metal lines attached to the vehicle underbody to carry refrigerant and engine coolant to and from the rear A/C evap ...

See also:

Lamp, side repeater, export
REMOVAL BULB NOTE: Side repeater lamps are used only on vehicles manufactured for certain export markets where they are required. Fig. 20: Remove/Install Repeater Lamp Bulb 1. Disconne ...

Removal
Fig. 56: BRAKE PEDAL HOLDING TOOL 1. Using a brake pedal holding tool as shown, depress the brake pedal past its first one inch (25 mm) of travel and hold it in this position. This will isolate ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...