Installation

CAUTION: To prevent damage to the plastic evaporator tube bracket, carefully guide the heater core tubes past the bracket during installation of the heater core. Fig. 278: Re ...

Description, Operation

DESCRIPTION Fig. 284: Rear Evaporator Description The rear A/C evaporator (4) is located within the rear heater-A/C housing, behind the right interior quarter panel trim. The rear A/C evaporato ...

See also:

Muffler, exhaust
REMOVAL MUFFLER Fig. 16: Muffler/Exhaust Pipe Assembly - Single Tail Pipe - INSULATOR - MUFFLER/EXHAUST PIPE ASSEMBLY - BAND CLAMP NOTE: Band clamps (3) are spot welded to exhaust sy ...

Adjustments
NOTE: Perform all differential bearing preload measurements with the transfer shaft and gear removed. DIFFERENTIAL BEARING PRELOAD ADJUSTMENT USING EXISTING SHIM Fig. 348: Installing Too ...

Lamp, center high mounted stop
REMOVAL Fig. 5: Center High Mounted Stop Lamp 1. Disconnect and isolate the battery negative cable. 2. Remove the two screws (4) that secure the Center High Mounted Stop Lamp (CHMSL) (3) to t ...