Operation

SYSTEM The Powertrain Control Module (PCM) monitors many different circuits in the fuel injection, ignition, emission and engine systems. If the PCM senses a problem with a monitored circuit often ...

Pump, air

Description The air injection pump is located on the left side of the engine compartment. The pump is operated by an internal electrical motor and is mounted to a bracket by rubber isolators. An ...

See also:

Diagnosis and Testing
Rear Camera The hardwired circuits of the Rear View Camera (RVC) and those between the RVC and the radio receiver may be diagnosed using conventional diagnostic tools and procedures. The wiring ...

Installation
1. Guide the trailing end of the parking brake cable along the inboard side of the axle trailing arm up to the rear brake caliper. Make sure the cable is routed between the brake line and the tra ...

Removal, Installation
REMOVAL REMOVAL - NGC CONTROLLER Fig. 39: Remove/Install PCM NOTE: USE THE SCAN TOOL TO REPROGRAM THE NEW POWERTRAIN CONTROL MODULE (PCM) WITH THE VEHICLES ORIGINAL IDENTIFICATION NUMBER ( ...