Dodge Journey: Accessory drive

Cleaning, Inspection
CLEANING Drain cooling system and refill with clean water. Refer to drain and fill procedures in this service information . Run engine with radiator cap installed until upper radiator hose is ho ...

Belt, serpentine
Description Fig. 15: ACCESSORY DRIVE BELT - WORLD ENGINE - POWER STEERING PUMP - ACCESSORY DRIVE BELT - GENERATOR - CRANKSHAFT PULLEY - LOWER IDLER PULLEY - CRANKSHAFT PULLEY - WATE ...

See also:

Assembly
Fig. 65: Remove Input Shaft Bearing Cup NOTE: Always use ATF on all moving parts during this assembly procedure. 1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to r ...

Fluid, differential
Standard Procedure STANDARD PROCEDURE - DIFFERENTIAL ASSEMBLY FLUID CHANGE Fig. 79: Differential Assembly Fluid Change The drain plug (2) for the differential assembly is located in the bottom of ...

Installation
Fig. 40: Seal Protector - HALFSHAFT - SEAL PROTECTOR 1. Install halfshaft to hub/bearing assembly. Install hub nut and washer but do not tighten at this time. 2. Using Seal Protector 9 ...

0.3282