Description, Diagnosis and Testing

DESCRIPTION This vehicle is equipped with either an equal length halfshaft system, consisting of short halfshafts on both sides with an intermediate drive shaft on the right side, or an unequal le ...

Without intermediate shaft

NOTE: Never grasp the halfshaft assembly by the inner or outer boots doing so may damage to the boot. NOTE: The inner tripod joints are designed with a retention feature that prevents t ...

See also:

Cover, structural dust
Removal Fig. 172: Belly Pan 1. Raise and secure the vehicle on a hoist. 2. Remove the belly pan (2), if equipped. Fig. 173: Front Engine Mount Through Bolt 3. Remove the fore/aft crossmemb ...

Standard Procedure
MASTER CYLINDER BLEEDING 1. Clamp the master cylinder in a vise with soft-jaw caps. Fig. 88: BLEEDING MASTER CYLINDER WITH ABS 2. Thread a Bleeder Tube (2), Special Tool 8358-1, into the primary ...

Indicators
Indicators are located in various positions within the CCN and are all connected to the CCN electronic circuit board. All indicators, except the inverter indicator (if equipped), are controlled b ...