Dodge Journey: VIDEO ENTERTAINMENT SYSTEM (VES)™ — IF EQUIPPED

The optional Video Entertainment System (VES)™ includes the following components for rear seat entertainment: • A diagonal 8 in (20 cm) Liquid Crystal Display (LCD) screen integrated into the center overhead console.

The screen features brightness control for optimum daytime and nighttime viewing.

• The LCD Screen swings down from the console to allow the rear seat passenger(s) to view the display.

VES™ with Rear HVAC Controls
VES™ with Rear HVAC Controls

• The touch screen radio and DVD player controls allow front seat operation for easy setup in the case of younger rear seat passengers.

• A battery-powered infrared remote control that snaps into a molded compartment in the center console.

• Two wireless infrared headsets allow rear seat passengers to listen to the same or individual audio sources.

Jacks)Audio/Video RCA Jacks (AUX
Jacks)
on the rear of the center console enable the monitor to display video directly from a video camera, connect video games for display on the screen, or play music directly from an MP3 player.

1. Video in (yellow).

2. Left audio in (white).

3. Right audio in (red).

NOTE: Refer to your “Video Entertainment System (VES)™ User Manual” for detailed operating instructions.

    Uconnect™ Multimedia (SIRIUS BACKSEAT TV™) — IF EQUIPPED
    Satellite video uses direct satellite receiver broadcasting technology to provide streaming video. The subscription service provider is SIRIUS Satellite Radio. SIRIUS Backseat TV™ offers three vi ...

    UNIVERSAL CONSUMER INTERFACE (UCI) 0.5 — IF EQUIPPED
    NOTE: This section is for sales code RES/REL and REQ/RET radios only with uconnect . For sales code RBZ/REN/REZ touch screen radio and REU/REX/RE1 radio, refer to the separate User’s Manual. Thi ...

    See also:

    Description, Operation
    DESCRIPTION Fig. 1: COOLING SYSTEM - OVERVIEW - WINDSHIELD WASHER RESERVOIR - UPPER SUPPORT - FAN SHROUD - FAN MOTOR - LOWER RADIATOR HOSE The cooling system consists of an engine co ...

    Assembly
    Fig. 65: Remove Input Shaft Bearing Cup NOTE: Always use ATF on all moving parts during this assembly procedure. 1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to r ...

    Installation
    Fig. 40: Seal Protector - HALFSHAFT - SEAL PROTECTOR 1. Install halfshaft to hub/bearing assembly. Install hub nut and washer but do not tighten at this time. 2. Using Seal Protector 9 ...

    0.0091