Crossmember, rear suspension

REMOVAL 1. Raise and support the vehicle. Fig. 52: Tire And Wheel Mounting 2. On each side of the vehicle, remove the wheel mounting nuts (3), then the front tire and wheel assembly (1). Fi ...

Description, Operation

DESCRIPTION CAUTION: Grid lines can be damaged or scraped off with sharp instruments. Care should be taken in cleaning glass or removing foreign materials, decals or stickers. Normal glass ...

See also:

Flow check
To determine whether coolant is flowing through the cooling system, use one of the following procedures: PREFERRED METHOD WARNING: Do not remove the cooling system pressure cap or any hose ...

Assembly
Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...

Bearing(s), connecting rod
Standard Procedure CONNECTING ROD AND BEARING FITTING CONNECTING ROD BEARING Fig. 166: Checking Connecting Rod Bearing Clearance-Typical Fit all connecting rods on one bank until complete. Th ...