Dodge Journey: REPORTING SAFETY DEFECTS

In the 50 United States and Washington, D.C.

If you believe that your vehicle has a defect that could cause a crash or cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying the manufacturer.

If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign. However, NHTSA cannot become involved in individual problems between you, your authorized dealer, and the manufacturer.

To contact NHTSA, you may either call the Auto Safety Hotline toll free at 1–888–327–4236 (TTY: 1–800–424– 9153), or go to http://www.safercar.gov; or write to: Administrator, NHTSA, 1200 New Jersey Avenue, SE., West Building, Washington, D.C. 20590. You can also obtain other information about motor vehicle safety from http://www.safercar.gov.

In Canada

If you believe that your vehicle has a safety defect, you should contact the Customer Service Department immediately.

Canadian customers who wish to report a safety defect to the Canadian government should write to: Transport Canada, Motor Vehicle Defect Investigations and Recalls, 2780 Sheffield Road, Ottawa, Ontario K1B 3V9.

    MOPAR PARTS
    MOPAR fluids, lubricants, parts, and accessories are available from an authorized dealer. They are recommended for your vehicle in order to help keep the vehicle operating at its best. ...

    PUBLICATION ORDER FORMS
    To order the following manuals, you may use either the website or the phone numbers listed below. Visa, Mastercard, American Express, and Discover orders are accepted. If you prefer mailing your pa ...

    See also:

    AUTOSTICK — IF EQUIPPED
    AutoStick is a driver-interactive transmission that offers six manual ratio changes to provide you with more control of the vehicle. AutoStick allows you to maximize engine braking, eliminate undes ...

    Removal
    Fig. 25: Outer C/V Joint Seal Boot Clamps - SMALL CLAMP - SEALING BOOT - OUTER CV JOINT HOUSING - LARGE CLAMP - INTERCONNECTING SHAFT 1. Remove halfshaft assembly requiring boot repla ...

    Motor, blower, rear
    DESCRIPTION Fig. 191: Rear Blower The rear blower motor (1) is a 12-volt, direct current (DC) motor mounted within a plastic housing with an integral wire connector (4) and a squirrel cage-type ...

    0.0089