Dodge Journey: INTRODUCTION

Congratulations on selecting your new Chrysler Group LLC vehicle. Be assured that it represents precision workmanship, distinctive styling, and high quality - all essentials that are traditional to our vehicles.

This Owner’s Manual has been prepared with the assistance of service and engineering specialists to acquaint you with the operation and maintenance of your vehicle.

It is supplemented by a Warranty Information Booklet, located on the DVD, and various customer-oriented documents. Please take the time to read these publications carefully. Following the instructions and recommendations in this manual will help assure safe and enjoyable operation of your vehicle.

NOTE: After you read the manual, it should be stored in the vehicle for convenient referencing and remain with the vehicle when sold, so that the new owner will be aware of all safety warnings.

When it comes to service, remember that your authorized dealer knows your vehicle best, has factory-trained technicians and genuine MOPAR parts, and cares about your satisfaction.

    HOW TO USE THIS MANUAL
    Consult the Table of Contents to determine which section contains the information you desire. The detailed Index at the back of this manual contains a complete listing of all subjects. Consult the ...

    See also:

    Removal, Installation
    REMOVAL Fig. 54: Removing /Installing Propeller Shaft CAUTION: Propeller shaft removal is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while o ...

    MEDIA CENTER 130 (RES/RSC) — AM/FM STEREO RADIO WITH CD PLAYER (MP3 AUX JACK) AND SIRIUS RADIO
    NOTE: The radio sales code is located on the lower right side of the radio faceplate. RES/RSC Radio Operating Instructions — Radio Mode NOTE: The ignition switch must be in the ON or ACC posi ...

    Input shaft, transmission
    DISASSEMBLY Fig. 175: Snap Ring At Input Shaft 1. Remove the snap ring (2) that retains the input shaft bearing and sixth gear to the shaft. Fig. 176: Press Bearing From Input Shaft 2. Using ...

    0.0143