Removal, Installation

REMOVAL 1. Remove transmission and torque converter from vehicle. 2. Place a suitable drain pan under the converter housing end of the transmission. CAUTION: Verify that transmission is ...

Description, Operation

DESCRIPTION Fig. 430: Identifying Valve Body Assembly - VALVE BODY - T/C REGULATOR VALVE - L/R SWITCH VALVE - CONVERTER CLUTCH CONTROL VALVE - MANUAL VALVE - CONVERTER CLUTCH SWITCH V ...

See also:

Actuator, mode door, front
DESCRIPTION Fig. 12: Blend Door Actuators The mode door actuator (1) for the heating-A/C system is a reversible, 12-volt Direct Current (DC) servo motor, which is mechanically connected to the ...

With intermediate shaft
NOTE: Never grasp the halfshaft assembly by the inner or outer boots. This can cause damage to the boot, which will allow contaminants to enter the C/V joint. NOTE: The inner tripod joints ...

Operation
Fig. 427: Identifying Torque Converter Fluid Pressure Operation - APPLY PRESSURE - THE PISTON MOVES SLIGHTLY FORWARD - RELEASE PRESSURE - THE PISTON MOVES SLIGHTLY REARWARD The co ...