Arm, lower control

Diagnosis and Testing LOWER CONTROL ARM Inspect the lower control arm for signs of damage from contact with the ground or road debris. If the lower control arm shows any sign of damage, look for ...

Diagnosis and Testing

LOWER BALL JOINT 1. Raise the vehicle allowing the front suspension to hang. 2. Remove the tire and wheel assembly. 3. Using Dial Indicator C-3339A, or equivalent, attach the dial indicator mou ...

See also:

Assembly
NOTE: If the coil spring has been removed from the spring compressor, proceed with the next step, otherwise, proceed with 3. NOTE: To determine the flat coil end of the coil spring for the ...

Bearing(s), connecting rod
Standard Procedure CONNECTING ROD AND BEARING FITTING CONNECTING ROD BEARING Fig. 166: Checking Connecting Rod Bearing Clearance-Typical Fit all connecting rods on one bank until complete. Th ...

Standard Procedure
MASTER CYLINDER BLEEDING 1. Clamp the master cylinder in a vise with soft-jaw caps. Fig. 88: BLEEDING MASTER CYLINDER WITH ABS 2. Thread a Bleeder Tube (2), Special Tool 8358-1, into the primary ...