Dodge Journey: Evaporator, A/C, front

Installation
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant oil level will prevent the A/C system fro ...

Description, Operation
DESCRIPTION Fig. 238: Evaporator Description NOTE: LHD model shown. RHD model similar. The A/C evaporator (1) for the heating-A/C system is mounted in the HVAC housing, which is located be ...

See also:

Removal, Installation
REMOVAL REMOVAL - NGC CONTROLLER Fig. 39: Remove/Install PCM NOTE: USE THE SCAN TOOL TO REPROGRAM THE NEW POWERTRAIN CONTROL MODULE (PCM) WITH THE VEHICLES ORIGINAL IDENTIFICATION NUMBER ( ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...

Seal, output flange
REMOVAL Fig. 93: Axle Seal Removal - SEAL - SCREWDRIVER 1. Raise vehicle on hoist. 2. Remove rear driveline module. 3. Use suitable screwdriver (2) to remove output seal (1). INSTA ...

0.0168