Description, Operation

DESCRIPTION Fig. 1: COOLING SYSTEM - OVERVIEW - WINDSHIELD WASHER RESERVOIR - UPPER SUPPORT - FAN SHROUD - FAN MOTOR - LOWER RADIATOR HOSE The cooling system consists of an engine co ...

Preliminary checks

ENGINE COOLING SYSTEM OVERHEATING Establish what driving conditions caused the complaint. Abnormal loads on the cooling system such as the following may be the cause: Prolonged idle Very hig ...

See also:

Standard procedure
DRAINING When servicing the cooling system, it is essential that coolant does not drip onto the accessory drive belts and/or pulleys. Shield the belts with shop towels before working on the coolin ...

Bearing(s), connecting rod
Standard Procedure CONNECTING ROD AND BEARING FITTING CONNECTING ROD BEARING Fig. 166: Checking Connecting Rod Bearing Clearance-Typical Fit all connecting rods on one bank until complete. Th ...

Installation
Fig. 25: Ball Joint Installation 1. Install Installer (2), Special Tool 9964-1, and Installer (4), Special Tool 9964-2 on Remover/Installer (5), Special Tool 8441-1. Place a new ball joint (stem ...