Dodge Journey: Filter, engine oil
Removal
Fig. 256: Oil Filter & Drain Plug
1. Raise vehicle on hoist.
2. Position a suitable collecting container under oil filter location.
3. Remove oil filter (2) using a suitable oil filter wrench. Dispose of oil filter following environmental guidelines.
Installation
Fig. 257: Oil Filter & Drain Plug
1. Wipe filter base clean, then inspect gasket sealing surface.
2. Lubricate gasket of new filter with clean engine oil.
3. Install oil filter (2) and tighten to 16 N.m (12 ft. lbs.) after gasket contacts base. Use filter wrench if necessary.
4. Fill crankcase with proper engine oil to correct level if drained. Start engine and check for leaks.
Cooler and lines, oil
Description
Fig. 250: Oil Cooler Fasteners
Some 2.7L engines may be equipped with an engine oil cooler (2) that is
mounted to the rear transmission
mount bracket. Oil lines route oil from the e ...
Oil
Description
For engine oil type and capacity, refer to Vehicle Quick Reference/Capacities
and Recommended Fluids -
Description .
Standard Procedure
STANDARD PROCEDURE - ENGINE OIL AND FILTER CHA ...
See also:
Removal
WARNING: Review safety precautions and warnings in this part
before performing
this procedure. See Heating and Air Conditioning/Plumbing - Warning
and. Failure to
follow the warnin ...
Bearing(s), connecting rod
Standard Procedure
CONNECTING ROD AND BEARING FITTING
CONNECTING ROD BEARING
Fig. 166: Checking Connecting Rod Bearing Clearance-Typical
Fit all connecting rods on one bank until complete.
Th ...
REPORTING SAFETY DEFECTS
In the 50 United States and Washington, D.C.
If you believe that your vehicle has a defect that could
cause a crash or cause injury or death, you should
immediately inform the National Highway Traf ...
