With intermediate shaft

NOTE: The inner tripod joints are designed with a retention feature that prevents the tripod rollers from coming out of the inner joint housing up to a specific load. If this feature is o ...

Removal

Fig. 25: Outer C/V Joint Seal Boot Clamps - SMALL CLAMP - SEALING BOOT - OUTER CV JOINT HOUSING - LARGE CLAMP - INTERCONNECTING SHAFT 1. Remove halfshaft assembly requiring boot repla ...

See also:

Standard procedure
DRAINING When servicing the cooling system, it is essential that coolant does not drip onto the accessory drive belts and/or pulleys. Shield the belts with shop towels before working on the coolin ...

Diagnosis and testing
BATTERY The battery must be completely charged and the terminals should be properly cleaned and inspected before diagnostic procedures are performed. See Cleaning for the proper battery cleaning ...

Installation
NOTE: Perform 1 through 5 on each side of the vehicle to complete pad set installation, then proceed to 6. NOTE: Make sure that the audible wear indicator (if equipped) is placed toward ...