Dodge Journey: ENGINE BLOCK HEATER — IF EQUIPPED

Dodge Journey Owners Manual / STARTING AND OPERATING / ENGINE BLOCK HEATER — IF EQUIPPED

The engine block heater warms engine coolant and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord.

The engine block heater cord is bundled under the hood between the headlight assembly and the Totally Integrated Power Module (Fuse Box) on the driver’s side of the vehicle.

WARNING:
Remember to disconnect the cord before driving.

Damage to the 110-115 Volt electrical cord could cause electrocution.

    STARTING PROCEDURES
    Before starting your vehicle, adjust your seat, adjust the inside and outside mirrors, fasten your seat belt, and if present, instruct all other occupants to buckle their seat belts. WARNING: Nev ...

    AUTOMATIC TRANSMISSION
    CAUTION: Damage to the transmission may occur if the following precautions are not observed: • Shift into PARK only after the vehicle has come to a complete stop. • Shift into or out of REVER ...

    See also:

    JACKING AND TIRE CHANGING
    WARNING: • Do not attempt to change a tire on the side of the vehicle close to moving traffic. Pull far enough off the road to avoid the danger of being hit when operating the jack or changing t ...

    Description, Operation
    DESCRIPTION Two unique brake lamp switches are used in this vehicle, depending upon whether the vehicle was built during early or late production. These switches are not interchangeable and both a ...

    Installation
    1. Guide the trailing end of the parking brake cable along the inboard side of the axle trailing arm up to the rear brake caliper. Make sure the cable is routed between the brake line and the tra ...


    0.0208