Actuator, recirculation door

DESCRIPTION Fig. 15: Blend Door Actuators The recirculation door actuator (1) is a reversible, 12 volt direct current (DC) servo motor, which is connected directly to the pivot shaft lever of t ...

Description

MANUAL TEMPERATURE CONTROL (MTC) SINGLE ZONE The A/C-heater control for the front Manual Temperature Control (MTC) single zone system allows one temperature setting for the entire vehicle. All con ...

See also:

Removal, Installation
REMOVAL Fig. 54: Removing /Installing Propeller Shaft CAUTION: Propeller shaft removal is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while o ...

Bearing(s), crankshaft, main
Standard Procedure CRANKSHAFT MAIN BEARING FITTING Fig. 169: Cylinder Block Main Bore Grade Marking The grade marks for the cylinder block main bearing bore grade is located on the pan rail jus ...

Removal
LEFT-HAND DRIVE NOTE: The ABM is only separately serviceable for non-HSA (Hill Start Assist) equipped vehicles. Do not remove the ABM for vehicles equipped with HSA. 1. Disconnect the nega ...