Valve, exhaust gas recirculation (EGR)

Description The EGR valve consists of three major components. First there is the pintle, valve seat, and housing which contains and regulates the gas flow. Second there is the armature, return s ...

Description, Operation

DESCRIPTION OPERATION The following procedure has been established to assist technicians in the field with enabling and running OBD II Monitors. The order listed in the following procedur ...

See also:

Motor, blower, rear
DESCRIPTION Fig. 191: Rear Blower The rear blower motor (1) is a 12-volt, direct current (DC) motor mounted within a plastic housing with an integral wire connector (4) and a squirrel cage-type ...

Horn
REMOVAL Fig. 1: Removing / Installing Horns 1. Disconnect and isolate the negative battery cable. 2. Remove the push pin type retainers along the top of the grille assembly and position the g ...

Installation
LEFT-HAND DRIVE 1. Clean any debris off the mating surfaces of the HCU and ABM. CAUTION: When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant. ...