Installation

WITH FOOT LEVER 1. Pass most of the front parking brake cable down through the access hole in the floor pan from inside the vehicle. Fig. 195: CABLE HOUSING RETAINED IN LEVER 2. Insert the lev ...

Removal

1. Release the parking brake. 2. Manually release the parking brake cable tension. 3. Raise and support the vehicle. Fig. 206: TIRE AND WHEEL MOUNTING 4. Remove wheel mounting nuts (3), t ...

See also:

Seal, oil pump
REMOVAL Fig. 367: Removing Oil Pump Seal - SEAL PULLER C-3981-B - OIL PUMP SEAL 1. Remove transaxle from vehicle. 2. Using Seal Puller C-3981B (1) , remove oil pump seal (2). INSTALLA ...

Installation
FRONT NOTE: Inspect disc brake pads before installation. Fig. 169: VENTED BRAKE ROTOR MOUNTING 1. Clean the hub face (1) to remove any dirt or corrosion where the rotor mounts. 2. Insta ...

FUSES
Totally Integrated Power Module The Totally Integrated Power Module (TIPM) is located in the engine compartment near the air cleaner assembly. This center contains fuses and relays. Totally Inte ...