Dodge Journey: Speed Control
SWITCH, SPEED CONTROL
REMOVAL
Fig. 1: Removing/Installing Horn Switch
WARNING: Disconnect and isolate the battery negative (ground) cable before beginning steering wheel removal or installation. Allow the front airbag system capacitor to discharge for two minutes before removing the steering wheel or any front airbag system component. This will disable the front airbag system. Failure to disconnect the battery could result in accidental front airbag module deployment and possible personal injury.
Do not place a non-deployed airbag face down on a hard surface as the airbag will propel into the air if accidentally deployed, and could result in serious or fatal injury.
1. Disconnect and isolate the negative battery cable before beginning steering wheel removal. Allow the front airbag system capacitor to discharge for two minutes before removing the steering wheel or any front airbag system component.
2. Turn off ignition.
3. Remove the driver's side airbag.
4. Disconnect electrical connector (1) from horn switch (2).
5. Remove mounting screws (3) and horn switch (2) from steering wheel.
Fig. 2: Identifying Speed Control Switch Screws & Electrical Connector
6. Disconnect electrical connector (1) from speed control switch (3).
7. Remove screws (4) from speed control switch (3).
8. Remove speed control switch (3) from steering wheel.
INSTALLATION
Fig. 3: Identifying Speed Control Switch Screws & Electrical Connector
1. Install speed control switch (3) onto the locating pin (2) in the steering wheel.
2. Install speed control switch mounting screws (4) and tighten screws to 1.6 N.m (15 ins. lbs.).
3. Connect electrical connector (1) to speed control switch (3).
Fig. 4: Removing/Installing Horn Switch
4. Install horn switch (2) to steering wheel.
5. Install horn switch mounting screws (3) and tighten screws to 8 N.m (71 ins. lbs.).
6. Connect electrical connector to horn switch.
7. Install driver's side airbag.
8. Connect negative battery cable, tighten nut to 4.5 N.m (40 in. lbs.).
9. Verify vehicle and system operation.
Wiring, trailer tow
DESCRIPTION Fig. 73: Instruction Sheet Are Placed In Glove Box Vehicles equipped with an optional Trailer Tow Preparation package have a trailer tow wiring harness and an instruction sheet (1) ...Brakes
...See also:
Warning, Caution
WARNING
WARNING: The A/C system contains refrigerant under high pressure.
Repairs should
only be performed by qualified service personnel. Serious or fatal
injury
may result from ...
Cover(s), engine timing
Removal
Fig. 349: FRONT SPLASH SHIELDS
1. Disconnect and isolate negative battery cable.
2. Drain cooling system.
3. Remove coolant pressure container.
4. Remove right front wheel and bel ...
Grid, defogger, rear
STANDARD PROCEDURE
GRID LINE AND TERMINAL REPAIR
WARNING: Materials contained in the Repair Kit (Part Number
04549275) may cause
skin or eye irritation. The kit contains epoxy resin an ...