Dodge Journey: Switch, horn
REMOVAL
WARNING: On vehicles equipped with an airbag, refer to Restraint SERVICE INFORMATION article for warnings and cautions before servicing the horn switch.
Fig. 3: Removing Horn Switch
1. Disconnect and isolate the battery negative cable.
2. Remove the driver airbag.
3. Disconnect the connector from the clockspring.
4. Remove the three mounting fasteners.
5. Remove the horn switch.
INSTALLATION
Fig. 4: Installing Horn Switch
1. Install the horn switch.
2. Install the three mounting fasteners.
3. Connect the electrical connector to the clockspring.
4. Install the driver airbag.
5. Connect the battery negative cable.
Horn
REMOVAL Fig. 1: Removing / Installing Horns 1. Disconnect and isolate the negative battery cable. 2. Remove the push pin type retainers along the top of the grille assembly and position the g ...See also:
Duct, instrument panel demister
Removal
WARNING: Disable the airbag system before attempting any steering
wheel, steering
column or instrument panel component diagnosis or service. Disconnect
and isolate the negati ...
Assembly
Fig. 333: Identifying Thrust Washer
- THRUST WASHER
NOTE: The differential is serviced as an assembly. Differential
service is limited to
bearing cups and cones. Any other differentia ...
Installation
HOUSING-AIR DISTRIBUTION
NOTE: LHD model shown in illustrations. RHD model similar.
Fig. 131: Air Distribution Housing-Removal/Installation
1. Position the air distribution housing (2) onto ...