Dodge Journey: Horn

REMOVAL

Horn System
Fig. 1: Removing / Installing Horns

1. Disconnect and isolate the negative battery cable.

2. Remove the push pin type retainers along the top of the grille assembly and position the grille aside.

3. Disconnect the wire harness connectors (3) from the horns (2).

4. Remove mounting bolt (1) securing the horn bracket and remove horns.

INSTALLATION

Horn System
Fig. 2: Removing / Installing Horns

1. Install the horn assemblies (2).

2. Install the horn mounting bolt (1).

3. Connect the wire harness connector (3).

4. Position the grille and install the retainers.

5. Connect the negative battery cable.

    Description, Operation, Diagnosis and Testing
    DESCRIPTION The dual-note horn system features two electromagnetic horn units. The horn system includes the following major components: Horn - The two horns are located at the front center of ...

    Switch, horn
    REMOVAL WARNING: On vehicles equipped with an airbag, refer to Restraint SERVICE INFORMATION article for warnings and cautions before servicing the horn switch. Fig. 3: Remov ...

    See also:

    Lines, A/C underbody, extension
    Description Fig. 310: Underbody A/C Extension Lines Description Models equipped with the rear heating-A/C system use metal lines attached to the vehicle underbody to carry refrigerant and engin ...

    Description, Operation
    DESCRIPTION Fig. 4: Rear View Camera The Rear View Camera (RVC) (4) (also known as ParkView), is a camera on chip device utilizing Complementary Metal Oxide Semiconductor (CMOS) technology. CMO ...

    Disassembly
    Fig. 200: Snap Ring At Output Shaft Case Bearing 1. Remove the snap ring (2) from the output shaft. Fig. 201: Output Shaft Case Bearing And Gear 2. Use Bearing Splitter P-334 (3), Cage 8925-3 ( ...


    0.0167