Dodge Journey: Reinforcement, bumper, front
REMOVAL
Fig. 23: Front Bumper Reinforcement
1. Remove the front fascia. See Removal .
2. Support bumper reinforcement (3) on a suitable lifting device.
3. Mark the position of the bolts (1) on frame rail to aid in installation.
4. Remove the smaller bolts (2) attaching bumper reinforcement (3) to frame rail.
5. Remove the larger bolts (1) attaching bumper reinforcement (3) to frame rail.
6. Remove bumper reinforcement (3) from vehicle.
INSTALLATION
Fig. 24: Front Bumper Reinforcement
1. Position the bumper reinforcement (3) on vehicle.
NOTE: Use marks made previously to properly position bumper reinforcement
2. Install the larger bolts (1) attaching bumper reinforcement (3) to frame rail. Tighten bolts (1) to 28 N.m (250 in. lbs.).
3. Install the smaller bolts (2) attaching bumper reinforcement (3) to frame rail.
4. Install front fascia.
Fascia, rear
REMOVAL
Fig. 15: Push Pins
1. Open the hatch.
2. Remove the 6 pushpins (1) securing the fascia (2).
Fig. 16: Rivets
3. Remove the rivets (2) and the Torx screw (3) around the wheel well for ...
Reinforcement, bumper, rear
REMOVAL
Fig. 25: Rear Bumper Reinforcement
1. Remove rear fascia. See Removal .
2. Support bumper reinforcement (1) on a suitable lifting device.
3. Mark position of bolts (2) on frame rail ...
See also:
Electrical
SWITCH, BRAKE FLUID LEVEL
Description
The brake fluid level switch (2) is mounted through the center of the fluid
reservoir. The switch can be serviced
separately from the master cylinder fluid r ...
Description
Fig. 246: Liquid/Suction Line Assembly with Rear A/C
NOTE: A/C liquid and suction line assembly with rear A/C shown. Front
A/C only line
assembly similar.
The A/C liquid line is serviced ...
Valve, one way check
Description
Fig. 16: AIR INJECTION CHECK VALVE
The air injection check valve (1) is a one-valve check valve that allows air
to flow in one direction only. The
valve is located at exhaust side o ...
