Dodge Journey: Removal, Installation
REMOVAL
Fig. 48: Lower Instrument Panel Knee Blocker
1. Disconnect and isolate the battery negative cable.
2. Remove the lower instrument panel knee blocker.
3. Remove upper steering column shroud.
4. Remove the instrument cluster bezel, reposition the instrument, and remove the upper WIN bracket attaching screw (1).
Fig. 49: WIN Electrical Connector And Antenna Connector
5. Disconnect the WIN electrical connector (1) and the antenna connector (3) from the WIN.
6. Utilize a trim stick or equivalent and gently pry WIN trim ring (2) away from the instrument panel.
7. Remove the lower WIN attaching screw (5).
8. Remove the lower WIN bracket attaching screw (4).
Fig. 50: Bracket-Wireless Ignition Node
9. Rotate the WIN (1) and (2) bracket to assist in removal from the instrument panel.
10. Remove the WIN from the instrument panel opening.
INSTALLATION
NOTE: The WIN initialization procedure is required whenever the WIN or shaft lock module is replaced on vehicles equipped with the shaft lock module.
Fig. 51: Bracket-Wireless Ignition Node
1. Rotate and position the WIN (1) and bracket (2) into the to instrument panel opening.
Fig. 52: WIN Electrical Connector And Antenna Connector
2. Install the lower WIN bracket attaching screw (4).
3. Install the lower WIN attaching screw (5).
4. Connect the WIN electrical connector (1) and antenna connector (3) to the WIN.
5. Install the WIN trim ring (2).
Fig. 53: Lower Instrument Panel Knee Blocker
6. Install the upper WIN bracket attaching screw (1) and reposition the instrument cluster into the instrument panel and install the instrument cluster bezel.
7. Install upper steering column shroud.
8. Install knee blocker.
9. Connect negative battery cable.
10. If necessary, program the WIN.
Description, Operation
DESCRIPTION This vehicle is equipped with a Wireless Ignition Node (WIN) (1). The WIN and the FOB with Integrated Key (FOBIK) are the primary components of the keyless ignition system. The only ...See also:
DOOR LOCKS
Manual Door Locks
To lock each door, push the door lock plunger on each
door trim panel downward. To unlock the front doors,
pull the inside door handle to the first detent. To unlock
the rear doo ...
ELECTRONIC VEHICLE INFORMATION CENTER (EVIC) — IF EQUIPPED
The Electronic Vehicle Information Center (EVIC) features
a driver-interactive display. It is located in the
instrument cluster below the fuel and temperature
gauges. Vehicles equipped with steerin ...
Flexplate
Removal
Fig. 198: Flex Plate
1. Remove transmission.
2. Remove flex plate attaching bolts (2).
3. Remove backing plate (3) and flex plate (1).
Installation
Fig. 199: FLEX PLATE
1. Posit ...