Dodge Journey: Monitor, media system
REMOVAL
Fig. 14: Removing / Installing Mounting Fasteners
1. Disconnect and isolate the battery negative cable.
2. Open the video screen to access the mounting fasteners.
3. Remove the mounting fasteners.
Fig. 15: Removing/Installing Video Monitor Connectors
4. If equipped, disconnect the rear heat control connector (1).
5. Disconnect the video monitor connectors (2) and remove the assembly from the vehicle.
Fig. 16: Fasteners
6. Remove the fasteners (1) and remove the rear A/C and heater control.
INSTALLATION
Fig. 17: Fasteners
1. Install the rear A/C and heater control and the fasteners (1).
Fig. 18: Removing/Installing Video Monitor Connectors
2. If equipped, connect the rear A/C and heater control connector (1).
3. Connect the video monitor connectors (2).
Fig. 19: Removing / Installing Mounting Fasteners
4. Install the mounting fasteners.
5. Connect the battery negative cable.
Module, satellite video
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Move the front passenger seat to the most forward position.
Fig. 8: Antenna & Electrical Connectors
3. Disconnect the three ...
Radio
STANDARD PROCEDURE
RADIO BACKUP
The radio hard disk drive (HDD) can be backed up to save customer data in the
event that a radio replacement is
required. This procedure can only be done with all ...
See also:
Seal, crankshaft oil, rear
Removal
Fig. 214: REAR MAIN SEAL-INSTALLED
The crankshaft rear oil seal is incorporated in the seal adapter
(2) and can not be removed from the adapter. The
crankshaft rear oil seal/seal adapte ...
Cable, shift
REMOVAL
Fig. 306: Identifying Knee Blocker
1. Remove the knee blocker (2).
Fig. 307: Identifying Shift Cable At Shifter
NOTE: Ensure the lock tab on the shift cable (2) is depressed before ...
Valve, one way check
Description
Fig. 16: AIR INJECTION CHECK VALVE
The air injection check valve (1) is a one-valve check valve that allows air
to flow in one direction only. The
valve is located at exhaust side o ...
