Dodge Journey: Removal, Installation

REMOVAL

Audio and Video
Fig. 6: Backup Camera & Liftgate & Lights

1. Disconnect the negative battery cable.

2. Remove the four retainers (1) holding the lightbar (5) to the liftgate (6).

3. Using a trim stick or equivalent, release the lightbar (5) from the clips.

4. Disconnect the electrical connectors from the backup camera (2) and the lights (3).

5. Disconnect the liftgate release cable (4) from the lightbar (5).

6. Remove the retainer from the back of the camera.

7. Unclip the camera cover from the lightbar.

8. Remove the camera mounting retainers.

9. Remove the camera from the lightbar.

INSTALLATION

Audio and Video
Fig. 7: Backup Camera & Liftgate & Lights

1. Install the camera to the lightbar.

2. Install the camera mounting retainers.

3. Clip the camera cover to the lightbar.

4. Install the retainer to the back of the camera.

5. Connect the liftgate release cable (4) to the lightbar (5).

6. Connect the electrical connectors to the backup camera (2) and the lights (3).

7. Install the lightbar to the tailgate.

8. Install the four retainers (1) holding the lightbar (5) to the liftgate (6).

9. Connect the negative battery cable.

    Diagnosis and Testing
    Rear Camera The hardwired circuits of the Rear View Camera (RVC) and those between the RVC and the radio receiver may be diagnosed using conventional diagnostic tools and procedures. The wiring ...

    Module, satellite video
    REMOVAL 1. Disconnect and isolate the negative battery cable. 2. Move the front passenger seat to the most forward position. Fig. 8: Antenna & Electrical Connectors 3. Disconnect the three ...

    See also:

    Description, Operation
    DESCRIPTION Fig. 2: Antilock Brake Module - ANTILOCK BRAKE MODULE (ABM) - HYDRAULIC CONTROL UNIT (HCU) - PUMP/MOTOR The Antilock Brake Module (ABM) is a microprocessor-based device which ...

    Description
    Fig. 1: Front Suspension Components This vehicle has a gas pressurized MacPherson strut type front suspension design. Each side of the front suspension consists of these major components: ...

    Assembly
    Fig. 65: Remove Input Shaft Bearing Cup NOTE: Always use ATF on all moving parts during this assembly procedure. 1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to r ...


    0.0127