Dodge Journey: IF YOUR ENGINE OVERHEATS

In any of the following situations, you can reduce the potential for overheating by taking the appropriate action.

• On the highways — Slow down.

• In city traffic — While stopped, put the transaxle in NEUTRAL, but do not increase engine idle speed.

CAUTION:
Driving with a hot cooling system could damage your vehicle. If the temperature gauge reads “H,” safely pull over and stop the vehicle. Idle the vehicle with the A/C turned off until the pointer drops back into the normal range. If the pointer remains on the “H,” and you hear continuous chimes, turn the engine OFF immediately, and call for service.

NOTE: There are steps that you can take to slow down an impending overheat condition: • If your air conditioner (A/C) is on, turn it off. The A/C system adds heat to the engine cooling system and turning the A/C off can help remove this heat.

• You can also turn the temperature control to maximum heat, the mode control to floor and the blower control to high. This allows the heater core to act as a supplement to the radiator and aids in removing heat from the engine cooling system.

WARNING:
You or others can be badly burned by hot engine coolant (antifreeze) or steam from your radiator. If you see or hear steam coming from under the hood, do not open the hood until the radiator has had time to cool. Never try to open a cooling system pressure cap when the radiator or coolant bottle is hot.

    HAZARD WARNING FLASHER
    The Hazard Warning flasher switch is located in the instrument panel switch bank, above the climate controls. Press the switch to turn on the Hazard Warning flasher. When the switch is activated, ...

    JACKING AND TIRE CHANGING
    WARNING: • Do not attempt to change a tire on the side of the vehicle close to moving traffic. Pull far enough off the road to avoid the danger of being hit when operating the jack or changing t ...

    See also:

    MEDIA CENTER 130 (RES/RSC) — AM/FM STEREO RADIO WITH CD PLAYER (MP3 AUX JACK) AND SIRIUS RADIO
    NOTE: The radio sales code is located on the lower right side of the radio faceplate. RES/RSC Radio Operating Instructions — Radio Mode NOTE: The ignition switch must be in the ON or ACC posi ...

    Installation
    Fig. 51: Front Hub And Bearing Mounting 1. If required, install the hub and bearing (1) by sliding it into the knuckle. 2. If installing hub and bearing, install the four bolts (2) fastening t ...

    Removal
    2.7L ENGINE Fig. 22: Belly Pan - BELLY PAN - EXHAUST EXTENSION PIPE 1. Remove the belly pan (2). Fig. 23: 2.7L Extension Pipe 2. Remove the fasteners (1), and remove the exhaust extens ...

    0.0088