Dodge Journey: Seal, axle drive shaft
REMOVAL
Fig. 197: Axle Shaft Seal Removal
1. Remove axle shaft.
2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1).
3. Tap on the pry tool (2) with a small hammer and remove axle shaft seal (1).
INSTALLATION
Fig. 198: Aligning Axle Shaft Seal With Axle Shaft Seal Bore
1. Clean axle shaft seal bore of any excess sealant.
2. Align (bellhousing side) axle shaft seal with axle shaft seal bore.
3. Install axle seal on Seal Installer 9928 and Handle C-4171 and insert into axle shaft seal bore.
4. Tap seal into position until seated against transaxle case.
Fig. 199: Differential Side Seal
5. Align axle shaft seal with axle shaft seal bore.
6. Install (case side) axle seal on Seal Installer 9934 and Handle C-4171 and insert into axle shaft seal bore.
7. Tap seal into position until seated against transaxle case.
8. Install axle shaft.
9. Check transaxle fluid level and adjust as necessary.
Mechanism, gearshift
REMOVAL Fig. 193: Shift Cables To Shifter 1. Detach gear shift boot from console. 2. Remove the center console assembly. 3. Remove rear power window switch (if equipped) and disconnect ha ...See also:
Installation
Fig. 97: Strut Upper Mounting Nuts
1. Raise the strut assembly (2) into the strut tower, aligning the three
studs on the strut assembly upper
mount with the holes in strut tower. Install the thr ...
Grid, defogger, rear
STANDARD PROCEDURE
GRID LINE AND TERMINAL REPAIR
WARNING: Materials contained in the Repair Kit (Part Number
04549275) may cause
skin or eye irritation. The kit contains epoxy resin an ...
POWER SUNROOF — IF EQUIPPED
The power sunroof switch is located between the sun
visors on the overhead console.
Power sunroof Switch
WARNING:
• Never leave children in a vehicle with the key in
the ignition switch. Occu ...