Dodge Journey: Mechanism, gearshift
REMOVAL
Fig. 193: Shift Cables To Shifter
1. Detach gear shift boot from console.
2. Remove the center console assembly.
3. Remove rear power window switch (if equipped) and disconnect harness from console.
4. Remove cables (2) from shift levers (3).
5. Remove the cables (1) from the bracket (5).
Fig. 194: Manual Transaxle Shifter
6. Remove the shifter assembly nuts (2) and remove shifter (3) from vehicle.
INSTALLATION
Fig. 195: Manual Transaxle Shifter
1. Install shifter assembly (3), Install and tighten nuts (2) to 7 N.m (61 in. lbs.).
Fig. 196: Shift Cables To Shifter
2. Install cables (2) to shifter levers (3) and secure cable to shifter bracket (5).
3. Install center console assembly.
4. Install rear power window switch (if equipped) and fasten harness to console
5. Attach gearshift boot to center console assembly.
6. Verify that shift pattern is aligned properly.
Lever, shift
REMOVAL Fig. 183: Air Cleaner And Inlet Tube Remove the engine cover. 1. Disconnect battery negative cable. 2. Remove air inlet tube (2) and air cleaner assembly (4). Fig. 184: Nut Crosso ...Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...See also:
Installation
2.4L
Fig. 65: Removing/Installing Spark Plug
CAUTION: Handle the spark plugs with care. Do not drop or force
the spark plugs into
the wells, damage to the electrodes and/or porcelain ...
Removal, Installation
REMOVAL
Fig. 54: Removing /Installing Propeller Shaft
CAUTION: Propeller shaft removal is a two-man operation. Never
allow propeller shaft
to hang from the center bearing, or while o ...
Fluid, differential
Standard Procedure
STANDARD PROCEDURE - DIFFERENTIAL ASSEMBLY FLUID CHANGE
Fig. 79: Differential Assembly Fluid Change
The drain plug (2) for the differential assembly is located in the bottom of ...