Dodge Journey: Installation
Fig. 474: Removing/Installing Valve Body
- - VALVE BODY
NOTE: If valve body assembly is being replaced or reconditioned, it is necessary to perform the PCM Quick Learn Procedure.
1. Install accumulators and springs as previously removed. Install valve body assembly to transaxle.
Fig. 475: Identifying Valve Body-To-Transaxle Case Bolts
- - VALVE BODY ATTACHING BOLTS (18)
- - VALVE BODY
2. Install and torque valve body-to-transaxle case bolts to 12 N.m (105 in. lbs.).
Fig. 476: Identifying Filter & O-Ring
- - OIL FILTER
- - O-RING
3. Install transaxle oil filter. Inspect the o-ring and replace if necessary.
Fig. 477: Removing/Installing Oil Pan
- - OIL PAN
- - 1/8 INCH BEAD OF RTV SEALANT
- - OIL FILTER
4. Ensure the transaxle oil pan and transaxle case sealing surfaces are clean and dry. Install an 1/8" bead of MOPAR Silicone Rubber Adhesive Sealant to the oil pan and install.
Fig. 478: Identifying Oil Pan Bolts
- - OIL PAN BOLTS (USE RTV UNDER BOLT HEADS)
5. Torque oil pan-to-transaxle case bolts to 19 N.m (165 in. lbs.).
6. Raise engine cradle crossmember into position.
7. Aligning index/scribe mark placed upon disassembly, Install four cradle-to-body bolts and torque to 162 N.m (120 ft. lbs.).
8. Lower vehicle.
9. Remove engine support fixture 8534B.
10. Raise vehicle.
11. Install and torque engine front and rear mount-to-cradle nuts to 54 N.m (40 ft. lbs.).
12. Lower vehicle.
13. Connect transmission range sensor connector.
14. Install manual valve lever to manual shaft.
15. Install gearshift cable to manual valve lever.
16. Install battery and tray.
17. Connect battery negative cable.
18. Fill transaxle with Mopar ATF +4 Transmission fluid.
Assembly
NOTE: Cleanliness through entire disassembly and assembly of the valve body cannot be overemphasized. When disassembling, each part should be washed in a suitable solvent, then dried by comp ...See also:
Synchronizer
DISASSEMBLY
Place synchronizer in a clean shop towel and wrap. Press on inner hub.
Carefully open up shop towel and
remove springs, balls, keys, hub, and sleeve.
CLEANING
Do not attempt to clean ...
SAFETY TIPS
Transporting Passengers
NEVER TRANSPORT PASSENGERS IN THE CARGO
AREA.
WARNING:
• Do not leave children or animals inside parked
vehicles in hot weather. Interior heat build-up may
cause seriou ...
Switch, oil pressure
Description
The engine oil pressure switch is located on the right side of the engine
block. The switch screws into the
engine main oil gallery. The normally closed switch provides an input throug ...