Dodge Journey: Knob, gearshift
REMOVAL
Fig. 357: Removing/Installing Gearshift Knob
1. Loosen the set screw (3) on the shift knob (2).
2. Hold in the shift knob button (1).
3. Pull up on the shift knob (2) while holding the shift knob button (1) in.
INSTALLATION
Fig. 358: Removing/Installing Gearshift Knob
1. While holding the shift knob button (1) in install the shift knob (1) onto the shift mechanism shaft (4).
2. Tighten the set screw (3).
Holding clutches
DESCRIPTION Fig. 356: Identifying 2/4 & Low/Reverse Clutches & Planetary Geartrain Components - FRONT PLANET CARRIER/REAR ANNULUS - 2/4 CLUTCH - L/R CLUTCH - REAR PLANET CARRIER ...Pump, transmission oil
DESCRIPTION Fig. 359: Identifying Transmission Oil Pump Assembly - PUMP HOUSING - OUTER PUMP GEAR - INNER PUMP GEAR - REACTION SHAFT SUPPORT - SEAL RINGS (4) - REACTION SHAFT - CRES ...See also:
Removal
WARNING: Refer to the applicable warnings and cautions for this
system before
performing the following operation. Failure to follow these instructions
may
result in serious or fat ...
Mechanism, gearshift
REMOVAL
Fig. 193: Shift Cables To Shifter
1. Detach gear shift boot from console.
2. Remove the center console assembly.
3. Remove rear power window switch (if equipped) and disconnect ha ...
Removal, Installation
REMOVAL
WARNING: Disable the airbag system before attempting any steering
wheel, steering
column, or instrument panel component diagnosis or service. Disconnect
and isolate the negat ...