Dodge Journey: Toe

Front Suspension
Fig. 115: Steering Wheel Holding Tool

1. Center the steering wheel and lock it in place using a steering wheel clamp.

NOTE: When setting toe, make sure to set rear toe to the preferred specifications before setting front toe to the preferred specifications

NOTE: Perform the following at each rear wheel as necessary.

Front Suspension
Fig. 116: Rear Toe Adjustment Cam Bolt

NOTE: Perform the following at each front wheel as necessary.

CAUTION: Do not twist the inner tie rod-to-steering gear boot (bellows) while turning the inner tie rod during front toe adjustment. It may be necessary to remove the clamp where the boot meets the inner tie rod.

Front Suspension
Fig. 117: Tie Rod Jam Nut

REAR TOE

NOTE: Perform the following at each rear wheel as necessary.

Front Suspension
Fig. 118: Rear Toe Adjustment Cam Bolt

2. While holding the cam bolt head (4) stationary, loosen the toe link mounting cam bolt nut (3).

3. Rotate the cam bolt head (4) left or right until the rear wheel toe for that rear wheel is set to the preferred specification. 4. While holding the cam bolt head (4) stationary, tighten the toe link mounting cam bolt nut (3) to 100 N.m (74 ft. lbs.).

FRONT TOE

NOTE: Perform the following at each front wheel as necessary.

CAUTION: Do not twist the inner tie rod-to-steering gear boot (bellows) while turning the inner tie rod during front toe adjustment. It may be necessary to remove the clamp where the boot meets the inner tie rod.

Front Suspension
Fig. 119: Tie Rod Jam Nut

5. Loosen the tie rod adjusting jam nut (1). Grasp the inner tie rod (3) and rotate it one way or the other until the front wheel toe is set to the preferred specification.

6. Tighten the tie rod adjusting jam nut to of 75 N.m (55 ft. lbs.).

7. Make sure the inner tie rod-to-steering gear boot is not twisted. If removed, reinstall the clamp where the boot meets the inner tie rod.

ALL

8. Remove the steering wheel clamp.

9. Remove the alignment equipment.

10. Road test the vehicle to verify the steering wheel is straight and the vehicle does not pull or wander.

SPECIFICATIONS

WHEEL ALIGNMENT

NOTE: All specifications are given in degrees.

NOTE: All wheel alignments are to be set with the vehicle at curb height.

NOTE: Curb (ride) height specifications can be found in the Curb Height Measurement procedure.

ALL EXCEPT EXPORT

EXPORT

    Wheel alignment
    PRE-WHEEL ALIGNMENT INSPECTION Before any attempt is made to change or correct the wheel alignment, the following inspection and necessary corrections must be made to the vehicle to ensure proper ...

    See also:

    Removal
    1. Release the parking brake. 2. Manually release the parking brake cable tension. 3. Raise and support the vehicle. Fig. 206: TIRE AND WHEEL MOUNTING 4. Remove wheel mounting nuts (3), t ...

    Removal
    2.0L TURBO DIESEL Fig. 2: Generator Cables 1. Remove engine cover. 2. Disconnect and isolate the negative battery cable. 3. Remove accessory drive belt. 4. Disconnect battery cable fro ...

    Installation
    LEFT-HAND DRIVE 1. Clean any debris off the mating surfaces of the HCU and ABM. CAUTION: When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant. ...

    0.0086