Dodge Journey: Description
Fig. 246: Liquid/Suction Line Assembly with Rear A/C
NOTE: A/C liquid and suction line assembly with rear A/C shown. Front A/C only line assembly similar.
The A/C liquid line is serviced in two sections. The front section of the A/C liquid line is the refrigerant line that carries liquid refrigerant from the A/C condenser to the A/C receiver/drier and is only serviced as an assembly with receiver/drier. The rear section of the A/C liquid line (1) carries liquid refrigerant from the A/C receiver/drier to the A/C expansion valve and includes the high side service port (2) and a fitting for the A/C pressure transducer (4). The rear section of the A/C liquid line is only serviced as an assembly with the A/C suction line (5). When equipped with rear A/C, the A/C liquid and suction line assembly includes connections for the underbody refrigerant lines (3).
NOTE: Replacement of the refrigerant line O-ring seals and gaskets is required anytime a refrigerant line is disconnected. Failure to replace the rubber O-ring seals and metal gaskets could result in a refrigerant system leak.
The A/C liquid and suction line assembly has no serviceable parts except for the metal gaskets, rubber O-ring seals and the service port valve cores. The O-ring seals used on the connections are made from a special type of rubber not affected by R-134a refrigerant. The O-ring seals and gaskets must be replaced whenever the A/C liquid/suction line assembly is disconnected.
The A/C liquid and suction line assembly cannot be repaired and must be replaced if leaking or damaged.
Line, A/C liquid
...Removal
WARNING: Review safety precautions and warnings in this part before performing this procedure. See Heating and Air Conditioning/Plumbing - Warning and. Failure to follow the warnin ...See also:
SEATS
Seats are a primary part of the Occupant Restraint System
of the vehicle. They need to be used properly for safe
operation of the vehicle.
WARNING:
• DO NOT allow people to ride in any area of y ...
Differential, transaxle
DESCRIPTION
Fig. 166: Differential Assembly
- RING GEAR
- PINION SHAFT
- DIFFERENTIAL CASE
- PINION GEAR
- SIDE GEAR
The BG6 differential is a conventional open design, and is integr ...
Installation
Fig. 67: Seal Protector
- HALFSHAFT
- SEAL PROTECTOR
1. Install driveline module to transmission jack. Secure module to jack.
2. Using Seal Protector 9099 (2), load halfshafts to differe ...