Installation

2.4L Fig. 52: 2.4L Knock Sensor CAUTION: Always torque knock sensors to the correct torque specification. Over or under tightening effects knock sensor performance. Ensure the electr ...

Removal

2.4L Fig. 59: Identifying Ignition Coil Electrical Connectors NOTE: Prior to removing coil, spray compressed air around coil top to make sure no dirt drops into the spark plug tube. 1. ...

See also:

FUSES
Totally Integrated Power Module The Totally Integrated Power Module (TIPM) is located in the engine compartment near the air cleaner assembly. This center contains fuses and relays. Totally Inte ...

Preliminary checks
ENGINE COOLING SYSTEM OVERHEATING Establish what driving conditions caused the complaint. Abnormal loads on the cooling system such as the following may be the cause: Prolonged idle Very hig ...

Installation
Fig. 28: Sealing Boot Installation on Interconnecting Shaft - SEALING BOOT - RAISED BEAD IN THIS AREA OF SEALING BOOT - GROOVE - INTERCONNECTING SHAFT 1. Slide new sealing boot clamp (2 ...