Dodge Journey: Installation
2.4L
Fig. 7: Capacitor 2.4L
- - Bolt
- - Capacitor
- - Connector
1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m (88.5 ft. lbs.).
2. Connect electrical connector (3).
3. Install engine cover.
4. Connect negative battery cable, tighten nut to 5 N.m (45 in. lbs.).
2.7L 1st
Fig. 8: 1st Ignition Capacitor - 2.7L
1. Install ignition coil capacitor and nut.
2. Tighten nut to 10 N.m (88.5 in. lbs.).
3. Attach electrical connector to capacitor.
4. Connect negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
2.7L 2nd
Fig. 9: 2nd Ignition Capacitor - 2.7L
1. Install ignition coil capacitor (2) and bolt (1).
2. Tighten bolt to 28 N.m (20.5 ft. lbs.).
3. Connect electrical connector (3).
4. Connect negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
3.5L
Fig. 10: Ignition Capacitor - 3.5L
1. Install ignition coil capacitor (2) and bolt (1).
2. Tighten bolt to 28 N.m (20.5 ft. lbs.).
3. Connect electrical connector (3).
4. Connect negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
Removal
2.4L Fig. 3: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Disconnect and isolate negative battery cable at battery. 2. Remove engine cover. 3. Remove electrical connector (3). ...Coil, ignition
...See also:
Lamp, side repeater, export
REMOVAL
BULB
NOTE: Side repeater lamps are used only on vehicles manufactured for
certain export
markets where they are required.
Fig. 20: Remove/Install Repeater Lamp Bulb
1. Disconne ...
Electrical
SWITCH, BRAKE FLUID LEVEL
Description
The brake fluid level switch (2) is mounted through the center of the fluid
reservoir. The switch can be serviced
separately from the master cylinder fluid r ...
Frame
SPECIFICATIONS
FRAME DIMENSIONS
Frame dimensions are listed in metric scale. All dimensions are from center
to center of Principal Locating
Point (PLP), or from center to center of PLP and fasten ...