Dodge Journey: Removal
2.4L
Fig. 3: Capacitor 2.4L
- - Bolt
- - Capacitor
- - Connector
1. Disconnect and isolate negative battery cable at battery.
2. Remove engine cover.
3. Remove electrical connector (3).
4. Remove mounting bolt (1) and ignition capacitor (2).
2.7L 1st
Fig. 4: 1st Ignition Capacitor - 2.7L
1. Disconnect and isolate the negative battery cable.
2. Disconnect the electrical connector.
3. Remove nut and capacitor.
2.7L 2nd
Fig. 5: 2nd Ignition Capacitor - 2.7L
The ignition capacitor is located under the intake manifold on the drivers side of the engine.
1. Disconnect and isolate negative battery cable at battery.
2. Remove electrical connector (3).
3. Remove mounting bolt (1) and ignition capacitor (2).
3.5L
Fig. 6: Ignition Capacitor - 3.5L
The ignition capacitor is located on the drivers side of the engine.
1. Disconnect and isolate negative battery cable at battery.
2. Remove electrical connector (3).
3. Remove mounting bolt (1) and ignition capacitor (2).
Installation
2.4L Fig. 7: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m (88.5 ft. lbs.). 2. Connect electrical connect ...See also:
Without intermediate shaft
NOTE: The inner tripod joints are designed with a retention feature
that prevents the
tripod rollers from coming out of the inner joint housing up to a specific
load. If
this feature is o ...
Pump, water
Description
2.4L
Fig. 80: WATER PUMP - WORLD ENGINE
- ACCESSORY DRIVE BELT
- WATER PUMP PULLEY
- WATER PUMP
The water pump (3) on the world engine is attached to the water pump adapter ...
Standard procedure, Removal
STANDARD PROCEDURE
FRONT LAMP UNIT MOISTURE CLEARING
Some occasional moisture accumulation inside a vented front lamp unit is
normal and appears as a fogging on
the inside of the lamp lens, simil ...