Dodge Journey: Sensor, mass air flow (MAF)
Removal
Fig. 10: MASS AIR FLOW SENSOR
1. Disconnect air flow sensor electrical connector (4).
2. Remove constant tension clamps (1), (2) securing the air flow sensor (3).
3. Remove air flow sensor (3) from hoses.
Installation
Fig. 11: MASS AIR FLOW SENSOR
1. Note the arrow direction on the sensor and correctly position the air flow sensor (3) to hoses.
2. Install constant tension clamps (1), (2) to secure air flow sensor (3) to hoses.
3. Connect air flow sensor electrical connector (4).
Pump, air
Description The air injection pump is located on the left side of the engine compartment. The pump is operated by an internal electrical motor and is mounted to a bracket by rubber isolators. An ...Tube, air pump, inlet
Description The air pump inlet tube is located on the left side of the engine compartment. The tube attaches to the air injection pump using a quick connect style fitting. The other end of the tub ...See also:
Installation
2.4L
Fig. 52: 2.4L Knock Sensor
CAUTION: Always torque knock sensors to the correct torque
specification. Over or
under tightening effects knock sensor performance. Ensure the electr ...
Installation
Fig. 404: Identifying Shifter Mounting Bolts
1. Install the shifter mounting bolts and tighten to 20 N.m (15 ft. lbs.) in
the proper sequence as indicated on
drawing.
Fig. 405: Identifying Sh ...
Standard procedure
REFRIGERANT SYSTEM SERVICE EQUIPMENT
WARNING: Refer to the applicable warnings and cautions for this
system before
performing the following operation. Failure to follow these instructio ...