Dodge Journey: Tube, water inlet
Removal
WATER INLET TUBE
Fig. 126: WATER PUMP INLET TUBE WORLD ENGINE
- - NUTS
- - WATER PUMP INLET TUBE
- - WATER PUMP HOUSING
The water pump inlet tube (2) connects the water pump to the coolant adapter. This tube is sealed by an O-ring and held in place by fasteners to the water pump housing.
1. Drain cooling system.
2. Remove the coolant adapter and secondary thermostat.
3. Raise and support vehicle.
4. Remove inlet tube mounting nuts (1).
5. Remove inlet tube (2).
Installation
WATER INLET TUBE
Fig. 127: WATER PUMP INLET TUBE WORLD ENGINE
- - NUTS
- - WATER PUMP INLET TUBE
- - WATER PUMP HOUSING
1. Inspect the O-ring for damage before installing the tube. Replace O-ring as necessary.
2. Lubricate O-rings with soapy water.
3. Install new water inlet gasket between tube and water pump housing (2).
4. Position water pump inlet tube (3) on water pump housing (2). Hand tighten nuts to aide in tube alignment.
5. Install secondary thermostat and coolant adapter. 6. Tighten coolant tube nuts (1) to 24 N.m (212 in. lbs.).
7. Fill cooling system.
Thermostat
Description 2.0L DIESEL/2.4L ENGINE Fig. 115: THERMOSTAT - AIR BLEED - SEAL - RETURN SPRING - PELLET CHAMBER The primary thermostat for the 2.0L diesel and 2.4L gas engines are locate ...Transmission
COOLER, TRANSMISSION OIL Description Fig. 128: TRANSMISSION OIL COOLER - Air Conditioning Condenser/Transmission Oil Cooler - Transmission Cooler Outlet - Transmission Cooler Inlet - Air ...See also:
Intermediate shaft, diesel
REMOVAL
2.0L DIESEL
1. Remove the right half shaft.
Fig. 50: 2.0L Diesel Right Half Shaft Components
2. Remove the two intermediate shaft bolts (1).
3. Remove the intermediate shaft (2).
...
Seal, crankshaft oil, rear
Removal
Fig. 214: REAR MAIN SEAL-INSTALLED
The crankshaft rear oil seal is incorporated in the seal adapter
(2) and can not be removed from the adapter. The
crankshaft rear oil seal/seal adapte ...
Standard procedure
DRAINING
When servicing the cooling system, it is essential that coolant does not drip
onto the accessory drive belts
and/or pulleys. Shield the belts with shop towels before working on the coolin ...